Presented by Eastman
Recorded on June 12, 2024
Learn how Eastman and Lubrizol identified how specific processing variables impact the adhesion strength of overmolded samples produced through 2k injection molding. The findings are believed to be applicable across various TPE and substrate combinations. Moreover, the guidance shared is believed to be particularly of interest when mechanical interlocks cannot be used, and material changes are not feasible but improvements in adhesion strengths are desired.
Watch the Webinar Recording
Download the Slides
Contact Eastman / Ask a Question
Contact Lubrizol / Ask a Question
The views, opinions and technical analyses presented here are those of the author or advertiser, and are not necessarily those of ULProspector.com or UL Solutions. The appearance of this content in the UL Prospector Knowledge Center does not constitute an endorsement by UL Solutions or its affiliates.
All content is subject to copyright and may not be reproduced without prior authorization from UL Solutions or the content author.
The content has been made available for informational and educational purposes only. While the editors of this site may verify the accuracy of its content from time to time, we assume no responsibility for errors made by the author, editorial staff or any other contributor.
UL Solutions does not make any representations or warranties with respect to the accuracy, applicability, fitness or completeness of the content. UL Solutions does not warrant the performance, effectiveness or applicability of sites listed or linked to in any content.